Description
Model N700M07 U-blox GPS Receiver Module based on the newest generation and original U-blox® NEO-7 series precise point positioning GNSS module technology,which combines excellent sensitivity with low power and includes variants optimised for cost and performance. Replaces NEO-6M series products.
• GNSS engine for GPS,QZSS,GLONASS
• High precision GNSS<1m
• DGPS by SBAS or RTCM
• Combines low power consumption and high sensitivity
• Upgrade alternative products of NEO-6 and NEO-5 families
• Raw measurement data(GPS)
Applications:
• Personal location tracking;
• PDA, Pocket PC and other Portable Devices;
• Pets Tracking;
• Cars,Trucks,Buses Positioning;
Performance:
Receiver type: 56-channel u-blox7 engine
GPS L1 C/A, GLONASS L1 FDMA,
QZSS L1 C/A,
SBAS: WAAS, EGNOS, MSAS
Gallilo E1B/C(ready to support)
Navigation update rate: Up to 10 Hz
GPS GLONASS
Accuracy Position: 2.5 m CEP 4 m
SBAS: 2.0 m CEP n.a.
SBAS + PPP: < 1 m CEP n.a.
Acquisition Cold starts: 30 s 32 s
Aided starts: 5 s n.a.
Reacquisition: 1 s 1 s
Sensitivity Tracking: –161 dBm –158 dBm
Cold starts: –147 dBm –139 dBm
Warm starts: –148 dBm –145 dBm
Assistance GPS
AssistNow Online
AssistNow Offline
AssistNow Autonomous
OMA SUPL & 3GPP compliant
Oscillator Crystal
RTC crystal Built-In
Anti jamming Active CW detection and removal
Memory Flash
Supported Antennas Active
Features:
• External active antenna support
• LED signal indicator
• Super-Capacitor backup
• Mounting Hole: 3mm
• Module size :25.4mm * 30.8mm
• Ceramic Antenna size :25mm*25mm
Below is the old information relating to the previous module.
NEO-7M GPS module.
3.3 Volt module with on board regulator.
The IO signals are 3.3 volt, however the module requires 5 volts DC to supply the on board 3.3 V regulator. The output is serial however these are logic level and not RS232 compatible.
In order to setup the module for use you need to run U-BLOX setup
You will need a USB to serial converter Click Here.
Use this module with your Arduino or Arduino Clone or Raspberry Pi or even Banana Pi all of which are available from QKITS.
Adrunio UNO will require a bit bang serial port or software emulation or use a MEGA which has 4 serial ports.
